Language:  Deutsch Française Русский Español Portuguesa italiano polski český magyar Türk 中國 한국의 العربية
OK
Callback
We call you back:		 OK
Products » Pipe Machining » Membrane wall cutting

Membrane wall sawing system for waterwall panels of boilers in on-site steam boiler maintenance applications

In maintenance of industrial high pressure steam boilers panel wall cold cutting is an important step before weld preparations. To avoid any heat affected zone (HAZ) on the boiler tubes of the water wall panels, the sawing of the defective panel wall tubes should be done not by flame cutting but instead with the BWC cutting system, that uses abrasive saws. The system increases safety of workers and works with high productivity. Due to the straight cut you will have less wearing of cutting discs and caused by the high cutting quality you have less after work.


Advantages:


  • No heat affected zone
  • increased safety of workers
  • less wearing of cutting discs
  • high productivity
  • high cutting quality
  • less after work

 		   Trennung Flossenrohre
 

Technical Data:


  • Power: 2500 - 3500 W
  • Max. Membrane length: 4,5 m
  • Max. pipe diam.: 63,5 mm
  • Rail Material: Aluminum
  • drive: pneumatic / electric

 
  Trennung Flossenrohre
 


Boiler tubes of all high pressure steam boiler manufacturers like ALSTOM, BABCOCK, LENTJES, FOSTER WHEELER, RAFAKO, STEINMÜLLER, MITSUI, HITACHI, BABCOCK & WILCOX, THERMAX can be machined with this powerfull equipment for water wall boilers.

PDF Boiler Wall Cutting SystemPDF Boiler Wall Cutting System